[Solved] Add dial/receive signalling mechanism for AppRTCDemo at client side

Question

There are two android apk available for WebRTC, appRtcDemo and webRtcDemo. appRtcDemo apk can be used for android device to browser connectivity. You need to provide room id to connect to one room. If you are the room initiator then you have to enter -1.
If you want to connect two android device then you have to compile and install webRtcDemo apk. This apk interface provide place to enter ip address of another device and vice versa then both device will be connected.

Please go through -> http://www.webrtc.org/reference/getting-started

For more information. Both the apks i’ve compiled and installed and checked how it works.

I was able to make calls successfully between two android device using webrtcdemo. But I tested using WLAN of my office network. I did not use it further because I was using apprtcdemo for app reference. My suggestion is when you enter remote ip in webrtcdemo,just check if loop-back is unchecked. I guess for you loop-back is enabled, so you are receiving your own video packet, though you have entered remote ip. Make sure loop-back is disabled while making call.

Accepted Answer

There are two android apk available for WebRTC, appRtcDemo and webRtcDemo. appRtcDemo apk can be used for android device to browser connectivity. You need to provide room id to connect to one room. If you are the room initiator then you have to enter -1.
If you want to connect two android device then you have to compile and install webRtcDemo apk. This apk interface provide place to enter ip address of another device and vice versa then both device will be connected.

Please go through -> http://www.webrtc.org/reference/getting-started

For more information. Both the apks i’ve compiled and installed and checked how it works.

I was able to make calls successfully between two android device using webrtcdemo. But I tested using WLAN of my office network. I did not use it further because I was using apprtcdemo for app reference. My suggestion is when you enter remote ip in webrtcdemo,just check if loop-back is unchecked. I guess for you loop-back is enabled, so you are receiving your own video packet, though you have entered remote ip. Make sure loop-back is disabled while making call.